Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| michka:research:microbial_fuel_cells [2014-07-11 10:30] – michka | michka:research:microbial_fuel_cells [2014-07-11 10:38] – michka | ||
|---|---|---|---|
| Line 21: | Line 21: | ||
| ===One Container Design=== | ===One Container Design=== | ||
| - | Wiring as electrode. | + | |
| ==Results== | ==Results== | ||
| - | Voltage changes with oxygenation. | + | * Peak voltage at 100mV, drops to 60, stable. |
| + | | ||
| ===One Container in Crate Design=== | ===One Container in Crate Design=== | ||
| + | |||
| + | * Layed down the jar in a crate covered with a plastic bag and filled with water. | ||
| + | * Five times bigger cathode, made of wiring, and then replaced by a flattened aluminium can. | ||
| ==Why ?== | ==Why ?== | ||
| - | Augemented cathode surface area & reduced water layer width for oxygen access. | + | |
| + | |||
| + | ==Results== | ||
| + | |||
| + | * No improved voltage with bigger wiring cathode. | ||
| + | * Improved voltage (300 mV) with aluminium can cathode. | ||
| + | * When putting directly the multimeter cathode in water, we obtain 600 mV. | ||
| + | |||
| + | ==Conclusion== | ||
| + | |||
| + | * The geometry of the multimeter cathode may be better for voltage than the one made of wiring or aluminium can. However, surface area is necessary to obtain current. | ||
| ===Crate Paper Design=== | ===Crate Paper Design=== | ||
| Line 46: | Line 60: | ||
| * Negative voltage when putting a rock on cathode to maintain it in water. | * Negative voltage when putting a rock on cathode to maintain it in water. | ||
| + | * No improved voltage by the new flat design. | ||
| + | * Still no current measurable, probably very low. | ||
| + | |||
| + | ==Conclusion== | ||
| + | |||
| + | * Is paper a good PEM ? | ||
| ===Two Containers Design=== | ===Two Containers Design=== | ||
| Line 57: | Line 77: | ||
| * If water is not clean, voltage increases up to 100 mV. | * If water is not clean, voltage increases up to 100 mV. | ||
| * Two multimeter electrodes in the mud: 10-80 mV depending on location. | * Two multimeter electrodes in the mud: 10-80 mV depending on location. | ||
| + | |||
| + | ===Overall Conclusion=== | ||
| + | |||
| + | * Maybe it needs a longer period to get started - eating up all the oxygen around the anode. | ||
| + | * Maybe our PEMs are not good. | ||
| ====Design Improvements Ideas==== | ====Design Improvements Ideas==== | ||
michka