Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
powerofthemud:intersession1 [2017-09-17 09:33] michkapowerofthemud:intersession1 [2017-09-20 16:19] (current) michka
Line 1: Line 1:
-=====Intersession #1=====+=====Power of the Mud - Intersession #1=====
  
 This page relates the parallel advances of the [[:powerofthemud|Power of the Mud]] project made respectively by [[http://zprod.org/|Paul Granjon]] in Cardiff and [[https://fo.am/people/michka.melo/|Michka Melo]] in Brussels between their intensive work session which took place in Cardiff in [[michka:research:microbial_fuel_cells:cardiff5|September 2016]] and [[michka:research:microbial_fuel_cells:cardiff6|May 2017]]. This page relates the parallel advances of the [[:powerofthemud|Power of the Mud]] project made respectively by [[http://zprod.org/|Paul Granjon]] in Cardiff and [[https://fo.am/people/michka.melo/|Michka Melo]] in Brussels between their intensive work session which took place in Cardiff in [[michka:research:microbial_fuel_cells:cardiff5|September 2016]] and [[michka:research:microbial_fuel_cells:cardiff6|May 2017]].
  
-===Cardiff, September 14th===+===Abstract===
  
-Je n’ai pas eu le temps d’avancer sur les MFCprochaine étape brancher le capteur de courant et faire une page web pour data monitoring/loggingfinir électrode graphite et tester le circuit maisonA ce jour deux Mudwatts sont toujours sans signe de viela première tourne à 3 ou blinks seconde.+   * Regarding the Mudwatts we set up during our last sessionthe first to start (during the session itself) maintained a high performance behaviorblinling around 3-4 times per second over the course of several monthsIt just slowed down a little during Christams holidaysbecause it dried up, but once watered, it was back on track. 
 +      * The other two never started. Paul consequently washed them and filled them back with the good estuary slush we provided to the first one, and they started, later and slower than our first champion. The first one blinked approximately once every 1.5 sec, the other once every sec. 
 +   * Regarding joule thief (JT) circuit tests, we managed to light up and LED with a voltage as low as 0.46 V and a current as low as 0.8 mA. 
 +      * As a comparison, we saw that the lowest voltage at which the LED would light up without the JT circuit would be 1.654 V. In these conditions, it would consume much less current (0.05 mA). 
 +   * During this intersession, we also exchanged first conceptual ideas regarding our upcoming robotic installation at V&A.
  
-===CardiffOctober 3rd===+===PaulSeptember 14th - Mudwatt news===
  
-Je n’ai pas eu le temps d’avancer sur les MFC, prochaine étape brancher le capteur de courant et faire une page web pour data monitoring/logging, finir électrode graphite et tester le circuit maison. A ce jour deux Mudwatts sont toujours sans signe de viela première tourne à ou blinks seconde.+   * Two Mudwatts are still not workingbut the one with the Barry estuary slush blinks 3-times per second.
  
-===Brussels, February 28th===+===Brussels, September 23rd - Joule thief circuit experiments===
  
-Images +{{>http://www.flickr.com/photos/foam/36951262630/  ?maxwidth=400}}\\
- Intentions boue+
  
-===Cardiff, March 6th===+==Setup==
  
-Images +   * Power source 
- Paresseux+      * Lab power supply with automatic current regulation 
 +      * 100 kohms adjustable resistor between the + pin of the power supply and the + pin of the currentmeter. 
 +   * Measurements 
 +      * Analog currentmeter going from 0 to 1 mA, placed in series between the adjustable resistor and the joule thief circuit. 
 +      * Digital voltmeter measuring the voltage between the - pole of the adjustable potentiometer and the ground. 
 +   * Joule thief (JT) circuit 
 +      * 2N3904 transistor 
 +      * Coil, made of 
 +         * A 2.5 cm ferrite tore 
 +         * 10 coils of wire 
 +         * A measured resistance around 0.7 ohm 
 +            * This measure may be imprecise, as a commercial 1 ohm resistor was measured at 1.6 ohm by the same digital ohmmeter 
 +         * A yellow LED 
 +         * A 1 ohm resistor in series between the + pin of the power supply and the feedback coil 
 +         * Connection pattern similar to [[https://www.youtube.com/watch?v=0GVLnyTdqkg|this one]]
  
-===CardiffMay 4th===+==Results=
 +   * LED on JT 
 +      * Little light spot on yellow LED at 0.46 V and 0.8 mAwhich disappears at 0.6 mA. 
 +      * We cannot see any visible difference when placing a 47 uF across the + and - of the power source. 
 +   * LED alone (fed by the power supply without the JT circuit) 
 +      * Little light spot at 1.654 V and 0.05 mA. 
 +      * Quite bright at 1.8 V and 0.3 mA. 
 +      * Very bright at 1.9 V and 0.4 mA. 
 +   * Therefore, current does not seem to be the limiting factor to feed the JT.
  
-“Ca se précise! Les deux Mudwatt dont j’ai changé la terre pour de la boue collectée au même endroit que la dernière fois fonctionnent, mais pas au même rendement que la première (1.5s pour l’une4s pour l’autre). Enfinau moins elles marchentY aurait-il moyen d’effectuer des mesures sur la composition de la boue pour voir si on peut booster le rendement en imitant la première batterie?+==Does it work to use a joule thief circuit to charge a capacitor ?== 
 + 
 +   * According to [[http://www.elperfecto.com/2011/01/22/joule-thief-and-capacitors/|this source]]it seems to work to put a capacitor as an output, as long as there is a diode (potentially an LEDto keep the voltage low. 
 +   * Very well explained in the article itself. 
 + 
 +===MichkaFebruary 28th - Robot concept ideas for V&A=== 
 + 
 +{{>http://www.flickr.com/photos/foam/36922072500/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/37146964032/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/36922073780/  ?maxwidth=400}}\\ 
 + 
 +===Paul, March 6th Robot concept ideas for V&A=== 
 + 
 +{{>http://www.flickr.com/photos/foam/37146961422/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/37146961872/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/37146961772/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/37146961692/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/36922071770/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/37146961552/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/37146961572/  ?maxwidth=400}}\\ 
 +{{>http://www.flickr.com/photos/foam/37129321366/  ?maxwidth=400}}\\ 
 + 
 +===Michka, end of April - Replicating the JT experiments=== 
 + 
 +   * The replication of the experiments performed during the intersession in September failed. 
 +   * As a consequence, we put aside this hypothesis for the moment. 
 + 
 +===Paul, May 4th - Mudwatt news=== 
 + 
 +   * The two non-working Mudwatt were washed and their mud source was replaced by the good slush which made the other Mudwatt work so well. 
 +   * After the usual setup time (few days), they started up slowly, one blinking every 1.5 s, and the other every 4s.
  • powerofthemud/intersession1.1505640816.txt.gz
  • Last modified: 2017-09-17 09:33
  • by michka