Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
wormfarm [2012-11-05 17:31] – imogen | wormfarm [2012-11-05 17:57] – imogen | ||
---|---|---|---|
Line 15: | Line 15: | ||
I hunted around Brussels looking for a bath tub, but to no avail, it just wasn't second hand bath tub season at the flea markets. So Plan B: I decided that I'd buy big plastic tubs which stack into each other (you can buy them at hardware store or office supply stores). I decided on a vertical design like this http:// | I hunted around Brussels looking for a bath tub, but to no avail, it just wasn't second hand bath tub season at the flea markets. So Plan B: I decided that I'd buy big plastic tubs which stack into each other (you can buy them at hardware store or office supply stores). I decided on a vertical design like this http:// | ||
- | Purchase:\\ 3 x blue plastic storage containers\\ 1 x lid\\ 5 x 15cm wooden blocks\\ Threaded tank inlet and washers\\ Total cost: about 50 Euro (could have been cheaper but I had to shop at the inner city hardware store, which was an experience in itself as none of the staff spoke English. Trying to ask for / draw / mime a threaded tank inlet was like playing charades in the dark). | + | Purchase:\\ 3 x blue plastic storage containers\\ 1 x lid\\ 5 x 15cm wooden blocks\\ Threaded tank inlet and washers |
+ | |||
+ | Total cost: about 50 Euro (could have been cheaper but I had to shop at the inner city hardware store, which was an experience in itself as none of the staff spoke English. Trying to ask for / draw / mime a threaded tank inlet was like playing charades in the dark). | ||
{{: | {{: | ||
Line 43: | Line 45: | ||
{{: | {{: | ||
- | A slight design flaw is that the bolts I used were very wide. I would have liked to drill the hole at the base of the tub, allowing the liquid to drain out, however the wide bolts created too much height, which would have meant liquid would be sitting in the bottom of the tub. So I went with a side drainage option, which will still mean that some liquid will get stuck in the bottom but it just takes a small tilt of the tub to drain it out. | + | A slight design flaw is that the bolts I used were very wide. I would have liked to drill the hole at the base of the tub, allowing the liquid to drain out the bottom, however the wide bolts created too much height, which would have meant liquid would be sitting in the bottom of the tub. So I went with a side drainage option, which will still mean that some liquid will get stuck in the bottom but it just takes a small tilt of the tub to drain it out. |
+ | |||
+ | **Step 4** | ||
+ | |||
+ | Place the wooden blocks in 4 corners of the 2nd tub. These blocks create space between the food layer and the composting layer. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Stack the tubs on top of one another. Voila, your worm farm is almost ready! | ||
+ | |||
+ | {{: | ||